Electrical engineering HPCL RVUNL ISRO GATE DDFC Previous Year question
Q1. If we want to represent a relation between number of link currents and number of branch current in a direction graph, we Should .
- use incident
- tie set
- cut set
- reduced incident
Q2. which class have higher distoration
- Class A
- Class B
- Class C
- Class AB
Q3. Poynting vector wattmeter works on _________
- heating effect
- Magnetic effect
- induction effect
- hall effect
Q4. In a RLC Current Induction is 20 mH and Capacator is 200 micro farad . find the resonance frequency of the circuit
- 1000 rad/sec
- 50 rad/sec
- 250 rad/sec
- 500 rad/sec
Q5. If the slip in on induction motor is 0.25 and the synchronous speed is 600 rpm the motor speed(in rpm)would be
- 900
- 750
- 125
- 450
Q6. For armature shunt which one of the following is not a possible requirements.
- it should have high thermal automativer fore
- it should carry current without excessive temperature rise
- its temperature coefficient must be low
- its resistance should not vary with time
Q7. Which of the following increase study state accuracy
- phase lead compensator
- phase lag compensator
- Integrator
- Differentiator
Q8. Which of the following instruments totalize events over a specified period of time.
- Indicating Instruction
- All type of analog instruction
- recording instruction
- integration instruction
Q9. The element have mobility ratio in Germanium is
- 1.2 : 1
- 2.8:1
- 1:1
- 2:1
Q10. The electron hole mobility ratio in silicon is
- 1:1
- 2:1
- 2.6:1
- 1.2:1
Q12. Out of the following what happens to the overall gain the system of a closed loop control
system with possative value of Feed back gain.
- Increase or Decrease
- Increase
- No-effect
- Decrease
Q13. A series or parallel RLC circuit is said to be over damped if
- alfa > wn
- 2alfa=wn
- alfa<wn
- alfa=wn
Q14. In a BJT collector region width is Maximum when it
1. collects maximum number of charge carrier
2. reduces heat dissipation per unit area out of these
- only 2 is correct
- only 1 is current
- none is correct
- both 1 and 2 are correct
Q15. For the measurement of high resistance following method are used
1. loss of charge method
2. direct deflection method
3. substitution method
which of the following is/are correct
- 1 and 2
- 2 and 3
- 1 and 3
- only 1
Also Check - HPCL RVUNL ISRO GATE DDFCL UPCL exam Questions